How Can I Decode the First Signal with go2DECODE?

Requirements

• go2DECODE software installed
• License dongle connected, maw file installed

Steps

1. Start go2DECODE
2. Set Input to DANA
3. Check that DANA is in "File" mode
4. Open from c:\Program Files\procitec\......\example-signals\HF\baudot\ the wav file baudot_sync_200bd_850hz.wav
5. DANA: Enable: remove DC, IF from wav file, Loop mode
6. DANA: Start playback
7. go2DECODE:"Modem List","Load Modem List...", select "Modems_HF_on air*
8. go2DECODE: Menu "Extra", select "Modem recognition", select "Start"
9. Check that Spectrum/Sonagram shows the signal centered
10. After a few seconds decoding should start