go2DECODE: How to decode the first signal?

go2DECODE: How to decode the first signal?

Requirements

  • go2DECODE software installed
  • License dongle connected, maw file installed

Steps

  • Start go2DECODE
  • Set Input to DANA
  • Check that DANA is in "File" mode

  • Open from "c:\Program Files (x86)\go2SIGNALS\go2DECODE 4.1.0\signals\HF\baudot\" the wav file
  • DANA: Enable: remove DC, IF from wav file, Loop mode
  • DANA: Start playback

  • go2DECODE: Menu "Extra", select "Modem recognition", select "Start"
  • Check that Spectrum/Sonagram shows the signal centered
  • After a few seconds decoding should start.

Last update on 2018-05-12 by Rolf Haenggi.

Go back